|
| | TcpUart () |
| |
| void | set_host (const char *host) |
| |
| void | set_port (uint16_t port) |
| |
| void | set_reconnect_interval (uint32_t ms) |
| |
| void | set_connected_sensor (binary_sensor::BinarySensor *sensor) |
| |
| void | set_disconnects_sensor (sensor::Sensor *sensor) |
| |
| void | set_server (bool server) |
| |
| void | set_allow (const socket::Ipv4AllowEntry *entries, size_t count) |
| |
| void | setup () override |
| |
| void | loop () override |
| |
| void | dump_config () override |
| |
| void | on_shutdown () override |
| |
| float | get_setup_priority () const override |
| |
| void | write_array (const uint8_t *data, size_t len) override |
| |
| bool | peek_byte (uint8_t *data) override |
| |
| bool | read_array (uint8_t *data, size_t len) override |
| |
| size_t | available () override |
| |
| size_t | available_for_write () override |
| |
| uart::UARTFlushResult | flush () override |
| |
| bool | is_connected () override |
| |
| void | load_settings (bool dump_config) override |
| |
| void | write_array (const std::vector< uint8_t > &data) |
| |
| void | write_byte (uint8_t data) |
| |
| void | write_str (const char *str) |
| |
| void | write_array_progmem (const uint8_t *data, size_t len) |
| |
| void | write_array_progmem (const uint8_t *data, size_t len) |
| |
| bool | read_byte (uint8_t *data) |
| |
| size_t | paced_write_room (uint32_t last_write_ms) |
| |
| virtual void | set_flush_timeout (uint32_t flush_timeout_ms) |
| |
| void | set_tx_pin (InternalGPIOPin *tx_pin) |
| |
| void | set_rx_pin (InternalGPIOPin *rx_pin) |
| |
| void | set_flow_control_pin (InternalGPIOPin *flow_control_pin) |
| |
| void | set_rx_buffer_size (size_t rx_buffer_size) |
| |
| size_t | get_rx_buffer_size () |
| |
| virtual void | set_rx_full_threshold (size_t rx_full_threshold) |
| |
| void | set_rx_full_threshold_ms (uint8_t time) |
| |
| size_t | get_rx_full_threshold () |
| |
| virtual void | set_rx_timeout (size_t rx_timeout) |
| |
| size_t | get_rx_timeout () |
| |
| void | set_stop_bits (uint8_t stop_bits) |
| |
| uint8_t | get_stop_bits () const |
| |
| void | set_data_bits (uint8_t data_bits) |
| |
| uint8_t | get_data_bits () const |
| |
| void | set_parity (UARTParityOptions parity) |
| |
| UARTParityOptions | get_parity () const |
| |
| void | set_baud_rate (uint32_t baud_rate) |
| |
| uint32_t | get_baud_rate () const |
| |
| void | load_settings () |
| | Load the UART settings.
|
| |
| template<typename F > |
| void | add_debug_callback (F &&callback) |
| |
| float | get_actual_setup_priority () const |
| |
| void | set_setup_priority (float priority) |
| |
| void | call () |
| |
| virtual void | on_safe_shutdown () |
| |
| virtual bool | teardown () |
| | Called during teardown to allow component to gracefully finish operations.
|
| |
| virtual void | on_powerdown () |
| | Called after teardown is complete to power down hardware.
|
| |
| uint8_t | get_component_state () const |
| |
| void | reset_to_construction_state () |
| | Reset this component back to the construction state to allow setup to run again.
|
| |
| bool | is_in_loop_state () const |
| | Check if this component has completed setup and is in the loop state.
|
| |
| bool | is_idle () const |
| | Check if this component is idle.
|
| |
| void | mark_failed () |
| | Mark this component as failed.
|
| |
| void | mark_failed (const LogString *message) |
| |
| void | disable_loop () |
| | Disable this component's loop.
|
| |
| void | enable_loop () |
| | Enable this component's loop.
|
| |
| void | enable_loop_soon_any_context () |
| | Thread and ISR-safe version of enable_loop() that can be called from any context.
|
| |
| bool | is_failed () const |
| |
| bool | is_ready () const |
| |
| virtual bool | can_proceed () |
| |
| bool | status_has_warning () const |
| |
| bool | status_has_error () const |
| |
| void | status_set_warning () |
| |
| void | status_set_warning (const char *message) |
| |
| void | status_set_warning (const LogString *message) |
| |
| void | status_set_error () |
| |
| void | status_set_error (const LogString *message) |
| |
| void | status_clear_warning () |
| |
| void | status_clear_error () |
| |
| | ESPDEPRECATED ("Use status_momentary_warning() without a name. Removed in 2027.5.0", "2026.11.0") void status_momentary_warning(const char *name |
| |
| void | status_momentary_warning (uint32_t length=5000) |
| | Set warning status flag and clear it after length ms.
|
| |
| void | status_momentary_warning (const LogString *message, uint32_t length=5000) |
| |
| | ESPDEPRECATED ("Use status_momentary_error() without a name. Removed in 2027.5.0", "2026.11.0") void status_momentary_error(const char *name |
| |
| void | status_momentary_error (uint32_t length=5000) |
| | Set error status flag and clear it after length ms.
|
| |
| void | status_momentary_error (const LogString *message, uint32_t length=5000) |
| |
| bool | has_overridden_loop () const |
| |
| const LogString * | get_component_log_str () const ESPHOME_ALWAYS_INLINE |
| | Get the integration where this component was declared as a LogString for logging.
|
| |
| bool | should_warn_of_blocking (uint32_t blocking_time, uint32_t &threshold_ms_out) |
| |
|
| void | check_logger_conflict () override |
| |
| void | sync_link_ () |
| |
| void | read_socket_ () |
| |
| bool | check_read_timeout_ (size_t len=1) |
| |
| friend | void::setup () |
| |
| friend | void::original_setup () |
| |
| void | set_component_source_ (uint8_t index) |
| | Set where this component was loaded from for some debug messages.
|
| |
| virtual void | call_setup () |
| |
| void | call_dump_config_ () |
| |
| void | enable_loop_slow_path_ () |
| |
| void | set_component_state_ (uint8_t state) |
| | Helper to set component state (clears state bits and sets new state)
|
| |
| bool | set_status_flag_ (uint8_t flag) |
| | Helper to set a status LED flag on both this component and the app.
|
| |
| bool | set_error_flag_ (const LogString *message) |
| | Set the error flag and log it; true when it was not set before.
|
| |
| void | set_interval (const char *name, uint32_t interval, std::function< void()> &&f) |
| | Set an interval function with a const char* name.
|
| |
| void | set_interval (uint32_t id, uint32_t interval, std::function< void()> &&f) |
| | Set an interval function with a numeric ID (zero heap allocation).
|
| |
| void | set_interval (InternalSchedulerID id, uint32_t interval, std::function< void()> &&f) |
| |
| void | set_interval (uint32_t interval, std::function< void()> &&f) |
| |
| bool | cancel_interval (const char *name) |
| | Cancel an interval function.
|
| |
| bool | cancel_interval (uint32_t id) |
| |
| bool | cancel_interval (InternalSchedulerID id) |
| |
| void | set_timeout (const char *name, uint32_t timeout, std::function< void()> &&f) |
| | Set a timeout function with a const char* name.
|
| |
| void | set_timeout (uint32_t id, uint32_t timeout, std::function< void()> &&f) |
| | Set a timeout function with a numeric ID (zero heap allocation).
|
| |
| void | set_timeout (InternalSchedulerID id, uint32_t timeout, std::function< void()> &&f) |
| |
| void | set_timeout (uint32_t timeout, std::function< void()> &&f) |
| |
| bool | cancel_timeout (const char *name) |
| | Cancel a timeout function.
|
| |
| bool | cancel_timeout (uint32_t id) |
| |
| bool | cancel_timeout (InternalSchedulerID id) |
| |
| void | defer (const char *name, std::function< void()> &&f) |
| | Defer a callback to the next loop() call with a const char* name.
|
| |
| void | defer (std::function< void()> &&f) |
| | Defer a callback to the next loop() call.
|
| |
| void | defer (uint32_t id, std::function< void()> &&f) |
| | Defer a callback with a numeric ID (zero heap allocation)
|
| |
| bool | cancel_defer (const char *name) |
| | Cancel a defer callback using the specified name, name must not be empty.
|
| |
| bool | cancel_defer (uint32_t id) |
| |
| void | status_clear_warning_slow_path_ () |
| |
| void | status_clear_error_slow_path_ () |
| |
TCP client or server presented as a UART. Bytes are copied unchanged.
Definition at line 19 of file tcp_uart.h.
Public Member Functions inherited from esphome::uart::UARTComponent
1.12.0