Namespaces
namespace	hon_protocol

namespace	smartair2_protocol

Data Structures
class	BeeperSwitch

class	DisplaySwitch

struct	HaierBaseSettings

class	HaierClimateBase

class	HealthModeSwitch

class	HonClimate

struct	HonSettings

class	HorizontalAirflowSelect

class	QuietModeSwitch

class	SelfCleaningButton

class	Smartair2Climate

class	SteriCleaningButton

class	VerticalAirflowSelect

Enumerations
enum class	ActionRequest : uint8_t { SEND_CUSTOM_COMMAND = 0 , TURN_POWER_ON = 1 , TURN_POWER_OFF = 2 , TOGGLE_POWER = 3 , START_SELF_CLEAN = 4 , START_STERI_CLEAN = 5 }

enum class	CleaningState : uint8_t { NO_CLEANING = 0 , SELF_CLEAN = 1 , STERI_CLEAN = 2 }

enum class	HonControlMethod { MONITOR_ONLY = 0 , SET_GROUP_PARAMETERS , SET_SINGLE_PARAMETER }

Functions
	ESPHOME_LOG_TAG (TAG, "haier.climate")

bool	check_timeout (std::chrono::steady_clock::time_point now, std::chrono::steady_clock::time_point tpoint, size_t timeout)

	PROGMEM_STRING_TABLE (HonAlarmMessages, "Outdoor module failure", "Outdoor defrost sensor failure", "Outdoor compressor exhaust sensor failure", "Outdoor EEPROM abnormality", "Indoor coil sensor failure", "Indoor-outdoor communication failure", "Power supply overvoltage protection", "Communication failure between panel and indoor unit", "Outdoor compressor overheat protection", "Outdoor environmental sensor abnormality", "Full water protection", "Indoor EEPROM failure", "Outdoor out air sensor failure", "CBD and module communication failure", "Indoor DC fan failure", "Outdoor DC fan failure", "Door switch failure", "Dust filter needs cleaning reminder", "Water shortage protection", "Humidity sensor failure", "Indoor temperature sensor failure", "Manipulator limit failure", "Indoor PM2.5 sensor failure", "Outdoor PM2.5 sensor failure", "Indoor heating overload/high load alarm", "Outdoor AC current protection", "Outdoor compressor operation abnormality", "Outdoor DC current protection", "Outdoor no-load failure", "CT current abnormality", "Indoor cooling freeze protection", "High and low pressure protection", "Compressor out air temperature is too high", "Outdoor evaporator sensor failure", "Outdoor cooling overload", "Water pump drainage failure", "Three-phase power supply failure", "Four-way valve failure", "External alarm/scraper flow switch failure", "Temperature cutoff protection alarm", "Different mode operation failure", "Electronic expansion valve failure", "Dual heat source sensor Tw failure", "Communication failure with the wired controller", "Indoor unit address duplication failure", "50Hz zero crossing failure", "Outdoor unit failure", "Formaldehyde sensor failure", "VOC sensor failure", "CO2 sensor failure", "Firewall failure", "Unknown")

template<typename Mode , size_t N>
Mode	airflow_order_at (const std::array< Mode, N > &order, size_t index)

void	esphome_logger (haier_protocol::HaierLogLevel level, const char tag, const char message)

void	init_haier_protocol_logging ()

Variables
constexpr size_t	COMMUNICATION_TIMEOUT_MS = 60000

constexpr size_t	STATUS_REQUEST_INTERVAL_MS = 5000

constexpr size_t	PROTOCOL_INITIALIZATION_INTERVAL = 10000

constexpr size_t	DEFAULT_MESSAGES_INTERVAL_MS = 2000

constexpr size_t	CONTROL_MESSAGES_INTERVAL_MS = 400

constexpr uint32_t	AIRFLOW_SELECT_DEBOUNCE_MS = 10000

constexpr size_t	SIGNAL_LEVEL_UPDATE_INTERVAL_MS = 10000

constexpr int	PROTOCOL_OUTDOOR_TEMPERATURE_OFFSET = -64

constexpr uint8_t	CONTROL_MESSAGE_RETRIES = 5

constexpr std::chrono::milliseconds	CONTROL_MESSAGE_RETRIES_INTERVAL = std::chrono::milliseconds(500)

constexpr size_t	ALARM_STATUS_REQUEST_INTERVAL_MS = 600000

const uint8_t	ONE_BUF [] = {0x00, 0x01}

const uint8_t	ZERO_BUF [] = {0x00, 0x00}

constexpr std::array< hon_protocol::VerticalSwingMode, 7 > VERTICAL_SWING_MODES_ORDER	PROGMEM

constexpr uint8_t	INIT_REQUESTS_RETRY = 2

constexpr std::chrono::milliseconds	INIT_REQUESTS_RETRY_INTERVAL = std::chrono::milliseconds(2000)

Enumeration Type Documentation

◆ ActionRequest

enum class esphome::haier::ActionRequest : uint8_t

strong

Enumerator
SEND_CUSTOM_COMMAND
TURN_POWER_ON
TURN_POWER_OFF
TOGGLE_POWER
START_SELF_CLEAN
START_STERI_CLEAN

Definition at line 16 of file haier_base.h.

◆ CleaningState

enum class esphome::haier::CleaningState : uint8_t

strong

Enumerator
NO_CLEANING
SELF_CLEAN
STERI_CLEAN

Definition at line 48 of file hon_climate.h.

◆ HonControlMethod

enum class esphome::haier::HonControlMethod

strong

Enumerator
MONITOR_ONLY
SET_GROUP_PARAMETERS
SET_SINGLE_PARAMETER

Definition at line 54 of file hon_climate.h.

Function Documentation

◆ airflow_order_at()

template<typename Mode , size_t N>

Mode esphome::haier::airflow_order_at	(	const std::array< Mode, N > &	order,
		size_t	index )

Definition at line 42 of file hon_climate.h.

◆ check_timeout()

bool esphome::haier::check_timeout	(	std::chrono::steady_clock::time_point	now,
		std::chrono::steady_clock::time_point	tpoint,
		size_t	timeout )

Definition at line 46 of file haier_base.cpp.

◆ ESPHOME_LOG_TAG()

esphome::haier::ESPHOME_LOG_TAG	(	TAG	,
		"haier.climate"	)

◆ esphome_logger()

void esphome::haier::esphome_logger	(	haier_protocol::HaierLogLevel	level,
		const char *	tag,
		const char *	message )

Definition at line 6 of file logger_handler.cpp.

◆ init_haier_protocol_logging()

void esphome::haier::init_haier_protocol_logging ( )

Definition at line 29 of file logger_handler.cpp.

◆ PROGMEM_STRING_TABLE()

esphome::haier::PROGMEM_STRING_TABLE	(	HonAlarmMessages	,
		"Outdoor module failure"	,
		"Outdoor defrost sensor failure"	,
		"Outdoor compressor exhaust sensor failure"	,
		"Outdoor EEPROM abnormality"	,
		"Indoor coil sensor failure"	,
		"Indoor-outdoor communication failure"	,
		"Power supply overvoltage protection"	,
		"Communication failure between panel and indoor unit"	,
		"Outdoor compressor overheat protection"	,
		"Outdoor environmental sensor abnormality"	,
		"Full water protection"	,
		"Indoor EEPROM failure"	,
		"Outdoor out air sensor failure"	,
		"CBD and module communication failure"	,
		"Indoor DC fan failure"	,
		"Outdoor DC fan failure"	,
		"Door switch failure"	,
		"Dust filter needs cleaning reminder"	,
		"Water shortage protection"	,
		"Humidity sensor failure"	,
		"Indoor temperature sensor failure"	,
		"Manipulator limit failure"	,
		"Indoor PM2.5 sensor failure"	,
		"Outdoor PM2.5 sensor failure"	,
		"Indoor heating overload/high load alarm"	,
		"Outdoor AC current protection"	,
		"Outdoor compressor operation abnormality"	,
		"Outdoor DC current protection"	,
		"Outdoor no-load failure"	,
		"CT current abnormality"	,
		"Indoor cooling freeze protection"	,
		"High and low pressure protection"	,
		"Compressor out air temperature is too high"	,
		"Outdoor evaporator sensor failure"	,
		"Outdoor cooling overload"	,
		"Water pump drainage failure"	,
		"Three-phase power supply failure"	,
		"Four-way valve failure"	,
		"External alarm/scraper flow switch failure"	,
		"Temperature cutoff protection alarm"	,
		"Different mode operation failure"	,
		"Electronic expansion valve failure"	,
		"Dual heat source sensor Tw failure"	,
		"Communication failure with the wired controller"	,
		"Indoor unit address duplication failure"	,
		"50Hz zero crossing failure"	,
		"Outdoor unit failure"	,
		"Formaldehyde sensor failure"	,
		"VOC sensor failure"	,
		"CO2 sensor failure"	,
		"Firewall failure"	,
		"Unknown"	)

Variable Documentation

◆ AIRFLOW_SELECT_DEBOUNCE_MS

uint32_t esphome::haier::AIRFLOW_SELECT_DEBOUNCE_MS = 10000

constexpr

Definition at line 32 of file hon_climate.cpp.

◆ ALARM_STATUS_REQUEST_INTERVAL_MS

size_t esphome::haier::ALARM_STATUS_REQUEST_INTERVAL_MS = 600000

constexpr

Definition at line 42 of file hon_climate.cpp.

◆ COMMUNICATION_TIMEOUT_MS

size_t esphome::haier::COMMUNICATION_TIMEOUT_MS = 60000

constexpr

Definition at line 16 of file haier_base.cpp.

◆ CONTROL_MESSAGE_RETRIES

uint8_t esphome::haier::CONTROL_MESSAGE_RETRIES = 5

constexpr

Definition at line 40 of file hon_climate.cpp.

◆ CONTROL_MESSAGE_RETRIES_INTERVAL

std::chrono::milliseconds esphome::haier::CONTROL_MESSAGE_RETRIES_INTERVAL = std::chrono::milliseconds(500)

constexpr

Definition at line 41 of file hon_climate.cpp.

◆ CONTROL_MESSAGES_INTERVAL_MS

size_t esphome::haier::CONTROL_MESSAGES_INTERVAL_MS = 400

constexpr

Definition at line 20 of file haier_base.cpp.

◆ DEFAULT_MESSAGES_INTERVAL_MS

size_t esphome::haier::DEFAULT_MESSAGES_INTERVAL_MS = 2000

constexpr

Definition at line 19 of file haier_base.cpp.

◆ INIT_REQUESTS_RETRY

uint8_t esphome::haier::INIT_REQUESTS_RETRY = 2

constexpr

Definition at line 16 of file smartair2_climate.cpp.

◆ INIT_REQUESTS_RETRY_INTERVAL

std::chrono::milliseconds esphome::haier::INIT_REQUESTS_RETRY_INTERVAL = std::chrono::milliseconds(2000)

constexpr

Definition at line 17 of file smartair2_climate.cpp.

◆ ONE_BUF

const uint8_t esphome::haier::ONE_BUF[] = {0x00, 0x01}

Definition at line 43 of file hon_climate.cpp.

◆ PROGMEM

std::array< hon_protocol::HorizontalSwingMode, 5 > HORIZONTAL_SWING_MODES_ORDER esphome::haier::PROGMEM

inlineconstexpr

Initial value:

{
    hon_protocol::VerticalSwingMode::HEALTH_UP,   hon_protocol::VerticalSwingMode::MAX_UP,
    hon_protocol::VerticalSwingMode::UP,          hon_protocol::VerticalSwingMode::CENTER,
    hon_protocol::VerticalSwingMode::DOWN,        hon_protocol::VerticalSwingMode::MAX_DOWN,
    hon_protocol::VerticalSwingMode::HEALTH_DOWN,
}

Definition at line 30 of file hon_climate.h.

◆ PROTOCOL_INITIALIZATION_INTERVAL

size_t esphome::haier::PROTOCOL_INITIALIZATION_INTERVAL = 10000

constexpr

Definition at line 18 of file haier_base.cpp.

◆ PROTOCOL_OUTDOOR_TEMPERATURE_OFFSET

int esphome::haier::PROTOCOL_OUTDOOR_TEMPERATURE_OFFSET = -64

constexpr

Definition at line 39 of file hon_climate.cpp.

◆ SIGNAL_LEVEL_UPDATE_INTERVAL_MS

size_t esphome::haier::SIGNAL_LEVEL_UPDATE_INTERVAL_MS = 10000

constexpr

Definition at line 38 of file hon_climate.cpp.

◆ STATUS_REQUEST_INTERVAL_MS

size_t esphome::haier::STATUS_REQUEST_INTERVAL_MS = 5000

constexpr

Definition at line 17 of file haier_base.cpp.

◆ ZERO_BUF

const uint8_t esphome::haier::ZERO_BUF[] = {0x00, 0x00}

Definition at line 44 of file hon_climate.cpp.

Namespaces

Data Structures

Enumerations

Functions

Variables

Enumeration Type Documentation

◆ ActionRequest

◆ CleaningState

◆ HonControlMethod

Function Documentation

◆ airflow_order_at()

◆ check_timeout()

◆ ESPHOME_LOG_TAG()

◆ esphome_logger()

◆ init_haier_protocol_logging()

◆ PROGMEM_STRING_TABLE()

Variable Documentation

◆ AIRFLOW_SELECT_DEBOUNCE_MS

◆ ALARM_STATUS_REQUEST_INTERVAL_MS

◆ COMMUNICATION_TIMEOUT_MS

◆ CONTROL_MESSAGE_RETRIES

◆ CONTROL_MESSAGE_RETRIES_INTERVAL

◆ CONTROL_MESSAGES_INTERVAL_MS

◆ DEFAULT_MESSAGES_INTERVAL_MS

◆ INIT_REQUESTS_RETRY

◆ INIT_REQUESTS_RETRY_INTERVAL

◆ ONE_BUF

◆ PROGMEM

◆ PROTOCOL_INITIALIZATION_INTERVAL

◆ PROTOCOL_OUTDOOR_TEMPERATURE_OFFSET

◆ SIGNAL_LEVEL_UPDATE_INTERVAL_MS

◆ STATUS_REQUEST_INTERVAL_MS

◆ ZERO_BUF